Sinotimer Mc101 Manual [portable] ✦ [ Tested ]

If using an SSR to control a high-current load, always attach a heat sink to prevent the relay from overheating.

Correct wiring is critical for safe operation. Always disconnect power before making connections. Refer to the specific diagram on your unit's label for the most accurate pinouts.

Connect the AC power supply to Terminals 1 and 2 (typically 120V/240V L and N). Sensor Connection: sinotimer mc101 manual

0.3% measurement accuracy with a maximum resolution of 0.1°C for thermocouples and RTDs.

Set "AT" to 1. The AT light on the panel will blink until the cycle is complete and the controller has calculated its PID constants. If using an SSR to control a high-current

For models, connect Terminal 5 (positive) and Terminal 4 (negative) to the control input of your Solid State Relay. Configuration and Setup

Connect the positive and negative leads to the designated input terminals (check label for polarity). Refer to the specific diagram on your unit's

Supports multiple thermocouple types (K, J, E, N) and thermal resistance (RTD) inputs.

For models, use the internal relay contacts to switch your load.

Connect the resistor element between Terminals 8 and 9 , with the third "extra" wire going to Terminal 10 . Control Output: