Mori Seiki Ex Alarm List (Pro)

The door lock confirmation signal did not reach the control within the allotted time. TURRET ILLEGAL MOVEMENT

The tool state prevents the ATC from returning or removing the tool in the spindle. Troubleshooting Steps Mori Seiki Alarm Codes Overview | PDF - Scribd

The hydraulic power unit reports a fault, such as low pressure or readiness failure. SENSORING TOOL IN SPINDLE mori seiki ex alarm list

The turret moved without a command; often caused by a faulty output driver or clamp signal. PANEL ALARM

Indicates a general failure on the operation panel or flat-panel, often requiring a hardware check. IMPROPER TURRET The door lock confirmation signal did not reach

Mori Seiki "EX" alarms are PLC-related messages that originate from the machine tool builder rather than the underlying CNC control (such as Fanuc or Mitsubishi). These alarms typically indicate mechanical, electrical, or sequence-related issues specific to the machine's peripheral hardware, such as the hydraulic unit, automatic tool changer (ATC), or door interlocks.

Below is a categorized list and troubleshooting guide for common Mori Seiki EX alarms. Common Mori Seiki EX Alarm Codes Alarm Code Description & Potential Cause NEED ZERO-RETURN SENSORING TOOL IN SPINDLE The turret moved without

Attempted cycle start without the chuck being properly clamped. DOOR NOT CLOSED The machine door is open, preventing cycle initiation. EX0069 DOOR LOCK CHECK TIME OVER

Cycle start was activated before completing X and Z-axis zero returns after a machine lock cancel. EDITING SWITCH KEY IS ON