If the sync procedure fails, check the battery voltage. Low battery is the most common cause of pairing issues. Gemel TXSHS alarm operating advice needed - UKGSer
If the fob lights up but the bike doesn't respond, you may be outside the 30-second window after the ignition is turned off. Try turning the ignition on and then off again. Gemel Txshs User Manual
If you arm the alarm more than one minute after turning off the ignition, you must hold Button 1 for longer than one second. If the bike is left deactivated for over an hour, the system may shut down to save battery; in this case, cycle the ignition to wake it up. Deactivating the Motion Sensor If the sync procedure fails, check the battery voltage
The system enters a 15-second "activation phase" where no alarm will be triggered. After this, it is fully active. Try turning the ignition on and then off again
The TXSHS remote typically features two buttons and a status LED: Used to arm the system. Button 2 (Smooth): Used to disarm the system.
Hi all, As I mentioned in one of my previous posts I was going to change the two small batteries in my BMW alarm box (Gemel TXSHS) Gemel TXSHS alarm operating advice needed - UKGSer
Perform the described above to reconnect the remote to the bike. Troubleshooting