Small valves located on top of the filter housings used to release trapped air from the system.
+--------------------------+-----------------------+------------------------------------------+ | Maintenance Task | Frequency | Purpose | +--------------------------+-----------------------+------------------------------------------+ | Check Filter Gauges | Daily | Monitor for pressure differential drops | | Purge Air via Petcocks | After filter change | Prevent pump cavitation & dry-running | | Clean Sump and Tank | Bi-Annually | Eliminate sludge and debris buildup | | Check Line Hose Wear | Monthly | Prevent dangerous line ruptures | +--------------------------+-----------------------+------------------------------------------+ Troubleshooting Faults chipblaster jv10 manual
Verify that the 3-phase power is fully on and the CNC control's M-code signal is active. Check the tank levels; the return pump will not run if the fluid level is too low. Small valves located on top of the filter
Ensure all lines are rated for at least to prevent dangerous line ruptures. Electrical & Interface Configuration Connect the system to a clean 460V / 3-phase power supply. Ensure all lines are rated for at least
The return pump will automatically cycle to equalize the sump and tank coolant levels. Adjusting System Pressure